help - if possible

[.DetroitKing.]

I need a carrier bearing for my 1995 camaro 3.4l
i didn't even know my car had a 2-piece driveshaft but it does and the carrier bearing is f'd up

i cant find one anywhere besdies mazza on m-59 / airport and they want $170 for it

can anyone find one for me?
or have one they would sell me?

[Derek]

wouldnt gettin a new driveshaft solve that or am I way off? just get a one piece for like 100

[BP_Z28]

just get a one piece

[.DetroitKing.]

that thought crossed my mind, but someone was trying to tell me i cant and all this other stuff

that would be a lot easier and cheaper if it's possible to do that

[BP_Z28]

you can get a 1 piece aluminum ds for a 3.4 .. nick has one on his I believe

much lighter that the crappy 2 piece on on our cars!

[.DetroitKing.]

do you think a driveshaft off a 98 ls1 would fit?
if not
can anyone sell me a 1pc driveshaft for my car?
the junkyards around here are horrible.

[Phantom409]

Ther is a place over her in GR called D&R Drive line that can make you a steel one but it's kinda far for ya

See if you can locate a Drive Line shop in your area
Bring them the 2 piece one and tell them you want a 1 piece shaft built.
I would guess that it would cost about 125.00 to have it built and balanced.

[badinfluence]

Any 93-02 driveshaft will work

get a 98-02 LS1 aluminum, i just sold one for $100

[Virtue]

jc my one layin around is steel dont sweat it bein aluminum or steel

[25thZ28]

a friend of mine had the carrier bearing tabs rib off the torque arm on his 95 and we put a 1 piece shaft in it, no problem at all. i have a steel one out of a 95 camaro you can have if you want to come pick it up. not sure what it'd be to ship one.

[Lucky SOB]

when u find one go and pick it up. dont risk someone dropping it or something and knocking it off balance.

[Virtue]

hes good im helping him

its his last day in lake orion before he leaves for college

[BP_Z28]

[93formulalt1]

Yeah, I put a one piece aluminum DS onto my '94 Camaro, I just had to swap the yoke from the old one. Cost me $150 and took a couple of hours to swap it. Totally worth it, the car actually felt a bit faster afterwards. Maybe it was an imaginary gain, maybe not. . . lol

[Virtue]

well it got done just in time jc is leaving tonight because last night we didnt get it finished i didnt have all the tools to get a old u-joint out

so today we took it to a local shop and he pressed it out and a new one in but he tossed the caps and said we never gave him them so we had to drive around and luckly found a u joint

guy was a complete ******* who pressed them in


but its done FINALLY