To Those that said it cant be done....

[wasjo6431]

Well it can, and yes im crazy, tomoro i will have driver side mounted, then to pull them off and fab the sheet metal and im goign to demple the new inner fenders to fit the interior panels back over them.... i left in the brackets to mount the rear seats back up too. ive still gotta take a hammer to the outter fenders to put in about a .5 inch outward lip better safe than sorry....
and do some fiberglassing where there are no panels at no more such as how i took 2 inchess off of the quarterpanel/rocker
but heres a few teasers.....

[JoeliusZ28]

that is looking mean as hell.

[Transamsfast]

Sorry i couldnt help you, i was busy and dont have a car to drive...good old michigan...Trans am doesnt like the cold

[kammi10]

who said what couldnt be done?

[WMCC Dino]

That does look mean as hell,can't wait to see it done.

[00firebird]

i hope you didnt chop the crap out of that fender, looks gooffy

[JoeliusZ28]

i hope you didnt chop the crap out of that fender, looks gooffy

lol how else would it fit? its not a finished product.

[wasjo6431]

i hope you didnt chop the crap out of that fender, looks gooffy

ahha i had to man its a 29.5x11.5
which is 29.9 in diameter. i had to cut 1.25 inches off the bumper and round it upward, ill make it look pretty later all i was concerned about was getting the tire on lol...
the quarter panel infront of the tire i had to take off a lil over 2 inches.
and round it up into the fender again.
ill lip the fenders. then its time for some body work, fiberglass, im goin to use marine bondo as the area will be warm.
then its time for me to go get some paint..... and spray the fenders.....
and inner wheel wells will be coated with undercoating event hough im using stainless steel and aluminum rivets before i get it welded.

it looks goofy cuz only one side is done so far. if i twas on the ground it be dif. but also int he pic of it on the side thats how its going to rest sitting the suspension is under load right now as i have the axle being held by the jackstands instead of the frame.
if u look at it from the front it look smean as hell with how it sits right now..

[wasjo6431]

adding this one more photo i guess i forgot to put it in with the rest.

[wasjo6431]

i just cant wait to get this thing done. i gotta put a cage in it tooo......

[Superman09]

Holy Tire Batman! Cant wait to see the finished product!

[MyBadZ28]

Well after all that work i would hope you hook up now. hurry up and finish it i want to see more pics.

[Phantom409]

Now that's some srious fab work
Looks awsome, keep us posted with pics

[WMCCjames]

That's alot of tire.

[choley]

Its lookin bad ass and cant wait to see the finished product