Nick's Truck Pics- 56k, Grab a Snickers. . .

[93formulalt1]

No! That's what's crazy about it, I have no idea where to start! I drove it to the car wash today to spray the crap out of the bed, and it ran fine the whole way there and the whole way back! My dad thinks it's the fuel pump. I disagree, because the truck would act like it's starving for gas, not like it's got a couple of cylinders out. . . I'm going to do a full tune-up next Thursday after I get paid, maybe a new set of plugs will help out some. At least it's kinda shiny now. . . lol

[WMCC Gary]

Did you see my above post?


SOUNDS LIKE A IAC PROBLEM!

[GETGONE]

IAC and pick up a new cap and rotor when you get plugs. All that stuff is fairly cheap and should be around $50 or so for all of it.

[JoeliusZ28]

are you saying my angle is too steep or yours is? my CV boots looked considerably better dropping only 3/4" like i was saying. Even at the height i had it there, mine werent binding at all and it drove fine. if yours is binding theyre steeper than that. and yea, if you decrank to the point that the halfshaft is nearly level (to rake it)... it will ride like a damn buick in the front.

[93formulalt1]

Well, I took a closer look at it, and the angles aren't really that extreme. Not nearly as steep as yours were in the pics you posted above. I'm going to check out the IAC when I get a chance. I already replaced the cap and rotor when I replaced the plug wires. I don't get paid until Thursday, so I'll go buy some more parts then. I need to do complete tune up's on both of my cars, so I'll keep you posted. The Camaro's starting to develop a ticker, so I'm on the lookout for an M6/LT1 combo donor car. . .