Tweet
Has anyone done this? Any pics?
-
sigpic
1996 Base Model
+2 cylinder mod -
The better question is why? If your spinning the tire in the rim with a radial at your power level your not running enough air pressure.Originally posted by jderry View Post
-
I was thinking about doing this with bias ply. I need some slicks for these 4.10s I am getting.Originally posted by Yoshi94sigpicOriginally posted by ryanwarby01Comment
-
Bias ply.sigpic
1996 Base Model
+2 cylinder modComment
-
Re: Rim screws on salad shooters?
Sure you need screws? FWIW, I run bias ply slicks without tubes. 4020# and a 1.7s 60'. Never spun the tire on the tube. I run 13-15# pressure any less and the tire run on the edges of the rubber.
Sent from my DROID BIONIC using Tapatalk 2Comment
-
I am not sure what I am doing yet. I just wanted to get an idea if others have done it. It almost looks like the lips of the rims would put the screws really low in the sidewall.sigpic
1996 Base Model
+2 cylinder modComment
-
You shouldn't need them, you will be fine just mounting them normally!sigpic
98' Trans Am - Huron Speed Turbo Car
Comment
-
If you screw them you'll need tubes for sure.2000 Formula
fixed slow junkComment
Comment