Announcement

Collapse
No announcement yet.

Rim Questions!?!?!?!

Collapse
X
Collapse
Who has read this thread:
 
  • Page of 2
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • #16
    Originally posted by WMCCjames View Post
    Backspace is from bead to axle mating face. I'm not up on 4th gen fitments but that backspace sounds wrong to me. 4th gens take a lot of backspace. How wide is the wheel?
    looks like a 10". Has M/T et streets, 26x11.5x15 iirc. Yeah i think they are going to be sticking out a bit. maybe a couple inches at most. A guy on LS1tech said he ran this same setup because otherwise you'd have to grind the caliper down and get spacers. 4th gens usually go abut 7.5" bs, so i found out.
    Pacesetter LT's, Pacesetter ORY, full MSD ign., 2 step, rear LCA's, SFC's, B&M Ripper, poly motor mounts, Nitto NT05R's, WS6 wheels, KYB AGX adj. suspension, Eibach Sprotline springs, Trickflow elbow w/K&N, All HVAC deleted w/ delete panel, no AIR, No EGR

    96 Z28 Camaro M6
    2008 Silverado quad cab LTZ

    Comment

    • #17
      A 10" wide wheel with 4-5" BS will stick out on a 4th gen no doubt. When I ran a 10" wide rim on my 3rd gen it required 6" BS and a 3rd gen rear is 2" narrower per side than a 4th so they will stick out like a mofo on your car...sorry.
      sigpic
      Turbo Charged LS1/T56

      Comment

      • #18
        I would NOT run those at all, it will look horrid.
        Doing less with more


        Comment

        Previous 1 2 template Next
        Working...
        X