Announcement

Collapse
No announcement yet.

Nano nitrous installed

Collapse
X
Collapse
Who has read this thread:
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Nano nitrous installed

    I finally have my nitrous kit installed after spending the past couple months chasing electrical problems and leaking fittings. I bought a plate kit this spring and decided to put a nano kit on it instead of a bottle heater. i put my nitrous bottle in the spare tire area and the nano bottle is on the deck. I put in a racetronix pump with hot wire kit to handle the extra fuel load. I'm running a 100 shot and im using a timing tuner to pull 6 degrees. I'm using a 52 nitrous jet with a 30 fuel jet and I've attached a picture of a plug after a wot pass. I think it may be a little lean on the 30 fuel jet, but it looked too rich on a 31. I may leave the 31 jet in and up the nitrous to a 54 to see if i can find a good middle ground. The car pulls strong and gear changes come much faster, but I'm excited to see how it runs against some other cars.
    sigpic
    CAMMED M6 (375RWHP/371RWTQ)

  • #2
    IMG_1067.jpgIMG_1069.jpgIMG_1071.jpg
    sigpic
    CAMMED M6 (375RWHP/371RWTQ)

    Comment


    • #3
      Looks good Chace!!!

      Comment


      • #4
        Chace - looks good. It's hard to tell in that picture if it's a shadow or a tan fuel ring.
        2000 Formula
        fixed slow junk

        Comment


        • #5
          Glad to hear you like it! Make sure to let us know when you run some numbers..
          sigpic
          U.S. Army 1983-2005
          11.20@122.37 1.51 60'

          Originally posted by WMCCjames

          "Plans Subject to change upon Sobering up"

          Comment


          • #6
            It's hard to tell from the plug picture, but there's a light tan fuel ring on the base of the porcelain. It's pretty light so I wasn't sure if I was getting too lean.
            sigpic
            CAMMED M6 (375RWHP/371RWTQ)

            Comment

            Working...
            X