Tweet
Well this is what I got going here. I got a Bryant crank but it's got 2.017 mains and the 1.85 rods which doesn't bother me cuz I got a set of carillo rods for that part. The stroke is 3.250. The thing I'm asking here is we can make something work to get it into a 327 block. But if spacers were possible I would like to get it into a 400 block. Clevite makes main bearings that fit but the outside diameter isn't the same as any block I know of so I know spacers are Gunna be custom so if anyone knows someone who could make them for me it would be greatly appreciated. I would like to get this into a block asap. Thanks everyone in advanced to see if we can get this crank in a block.
-
-
Those would be good if I had 327 size mains on the crank but the crank mains are only 2.017. So I'm Gunna need spacers made to fit the outer diameter of the bearings which is 2.2370 to go into a 350 or 400 block.Comment
-
so it was cut .013
have it polished to 20 under and use 20 under bearings and the normal sm to lg spacersComment
-
I thought that small journals had the journal size if 2.3 not 2.03 please correct my if I'm wrongComment
-
my mistake. i see what you are doing now.
clevite list 2.017 bearings and has a note about spacers but i cant fine it in the pdf
call STan at EVI. he plays with nascar stuffComment
-
I'll look also. If you find something let me know cuz I would really like to get something rolling on thisComment
-
also try speedway 800.979.0122
they sell the honda size rod bearings for that crank. they may be able to helpComment
-
Yea im Gunna call around tomorrow and see what people have but I'm pretty sure it's Gunna come down to custom spacers that the clevite bearings fit into.Comment
-
Anyone have anymore good ideas? Speedway didn't have anything for those main sizes. Anyone know of a place to get spacers made?Comment
Comment