Verify tooth pattern, first time gear install

[95z28]

My backlash is suppose to be between .007" and .009". after mutitple different angles I got a consistent .009"
Here is my pattern.
IMG_4882.JPGIMG_4884.JPG

[hoogiesngrinderz]

Looks to be a little close to the root. I'd go .002 less on the pinion shim and check again. Repeat if necessary to get it centered.

[WMCCjames]

You are close, but the Pinion is too deep.

[95z28]

Thanks for the help guys, I did a couple more set ups and this is my pattern with .004 off the pinion. adjusted my backlash to 7.
IMG_4911.JPGIMG_4913.JPG

[WMCCjames]

Not bad..I'd probably run that.

[95z28]

I felt good about it to and I verified the pattern with what motive recommends and seems to look good. I just need this to last until I can get enough together for a 9in. Thanks for help.