moser wheel studs need advice

[TRY MEH]

i have a moser 12 bolt with the screw in style wheel studs there 5/8 and 3 inch long which is way to long for my torque thrust II's

i have to bore my wheels out 1mm for the 5/8 studs to fit also, which i don't want to do but not a big deal since it will be a upgrade anyhow.

i just want to find a shorter 5/8's stud but cant locate any other than a trailer style not to sure if im going about this correctly.... =/

[kammi10]

you really should have looked into 1/2 inch studs if your going to run street wheels. 5/8's studs are generally more for race wheels not street wheels. im not even sure if anyone offers a lug nut that will even work with tapered style lug nuts for those wheels.

[1BADAIR]

afco sells them but not sure they will fit in the holes in the wheels.
why are the studs too long?

[TRY MEH]

I purchased the rear end used with these studs in it not thinking it would be an issue
I want to run a closed style lug nut without spacers.

Sounds like i may need to buy new axles to do what i want?

[kammi10]

I purchased the rear end used with these studs in it not thinking it would be an issue
I want to run a closed style lug nut without spacers.

Sounds like i may need to buy new axles to do what i want?

yes you will. the shortest 5/8 wheel stud is 2 inches long. and you will not find one that is closed off that long

[TRY MEH]

Would it work with a spacer?
Is there a part number u can give me for that 2inch one
I dont want my studs sticking way out past my wheel mainly, i could deal with running a open style lug if i have to.

[DETROITMUSCLE]

run an open style lug, unless you want to buy new axles thats the only way to do it properly.

[farmington]

Check if you can get 1/2" studs with the same screw in stud size

[TRY MEH]

If i can locate the studs and lugs to do it ill go that route
Hard to find anything to fit in my wheels

[TRY MEH]

Check if you can get 1/2" studs with the same screw in stud size

Ive tried but couldnt find anything went to a few parts stores looking

[1BADAIR]

I have opens that hold the wheels on then closed on top to cover the stud

[TB2]

Just have the axles re-drilled for whatever studs you want to use. Any reputable machine shop can do that for a reasonable price.

[TRY MEH]

I have opens that hold the wheels on then closed on top to cover the stud

Are u running 5/8's?
Were do i find this stuff?

Update on my studs there 4inch lenth 5/8's 18thread pich both ends

If i drilled and tapped my axles in a different spot wouldnt that take strength away and not be so safe? Dont want to mess balance up also.? Not sure how that works if i can do that ill do that

[TRY MEH]

???

[TRY MEH]

Found a place thats custom makes studs hope they csn make what i want!
I. Sure price will be a bit steep ill call them monday
http://www.wilsongarner.com/wheel-studs.html