12 bolt? What will it take to get it to fit?

[sman]

My dad is putting a different rear in his 69 nova, it currently has a Moser 12 bolt in it.

What would it take to get this thing in my car? Is it even possible? Worth it?

[1BADAIR]

alot. you would have to somehow make a TA mount . probably not the right width, disk brakes may not fir

[sman]

Wasnt sure if it was a big deal to get a tq arm mount for it or not, if it is then nevermind. Not that worried about it, it would need gears and stuff too. Not putting that much money into it.

[1BADAIR]

9 inch kinda has a bolt on mount that bolts to easiliy welded on tubes. 12 bolt mount is molded into the cast center

[bri2203]

you could get 12 bolt in a nova from the factory so it should be bolt in

[sman]

I didnt think the Novas used a tq arm from the factory? My dads car does not.

[DETROITMUSCLE]

you could get 12 bolt in a nova from the factory so it should be bolt in

Spencer was asking about putting the 12 bolt out of his Dad's nova into his f body. I think your getting it confused Brian.

[WMCCjames]

I didnt think the Novas used a tq arm from the factory? My dads car does not.

They don't. Any non f body 12 bolt that I have seen that's been adapted to an f body is a total hack job...just like a 8.8. Waste of time and money.

[Emulsifide]

9 inch or bust Spencer! Buy a third member from Roush Yates' used NASCAR parts store on the interwebs for $750 and go Moser for the housing and axles.

[bri2203]

Spencer was asking about putting the 12 bolt out of his Dad's nova into his f body. I think your getting it confused Brian.

Thanks Jeff, Yes I failed at reading well.