Tweet
Got to work today and my boss tells me that after we all left yesterday he noticed some oil on the ground...I immediatly think tranny...checked my fluids and everything checked out so I went home and opened my garage door and there was a huge red oil spot...so I took to the shop about a mile down the road and me and a buddy put it in the air and this is what we found...
-
burn rubber! -
Funny that I lost all that fluid and it never started grinding or making funny noises...well if anyone has recommendations I would appreciate them...also don't know if you can tell from the pic but the cut is pushed out not in...never felt anything let go in the trans...except reverse started falling out about two weeks ago...thanks to allburn rubber! -
Can you get it welded, then another plate on top of it to reinforce it?
Used to own a Firebird.Comment
-
Damn! That's some bad luck right there.- Brian Meissen
Owner, MiFBody.com
Administrator, LTxTech.com
1994 Camaro LT1 Transplant -
357ci LT1, cammed, stalled, and driven.
2022 Camaro LT1 - "Cherry Bomb 2"Michigan FBody Meet & Greet Car Show 2022
June 4th, 2022 - 9am to 3pm!!!
The HUB Stadium, Auburn Hills, MIComment
-
Awww man - that SUCKS!Gone but not forgotten: 1986 Chevrolet Camaro IROC-Z
"You shall ride eternal. Shiny and chrome."Comment
-
-
Sorry dude, good luck getting it fixed!sigpic1994 Camaro Z28 83K M6, CAI, AFR 190cc, 11.6:1, Hooker headers, Hooker ORY, Mangnaflow exhaust, AI 230/238, 1.6 RR, B&M Short throw, Hays clutch, 4.10 gear.
Member: The Mid Michigan Modern Muscle Car Club
Originally Posted by 1BADAIR
manuals should be launched off the limiter and the throttle shouldn't leave the floor til 10 feet after the finish lineComment
-
Hope you get it fixed.
VicePresident of West Michigan Firebird Club
A.K.A The Maverick
http://www.cardomain.com/ride/660128/1
93 TA Currently Under Construction AGAIN
2007 2500 Chevy Silverado Crew Cab w/ 6.0L & 3.73'sComment
-
That sucks dude...
sigpic
U.S. Army 1983-2005
11.20@122.37 1.51 60'
Originally posted by WMCCjamesComment
-
Well I think I will take the advice of a few and have it grinded smooth, welded, and then a square plate welded over that so hopefully soon I can be driving it again!!!burn rubber!Comment
Comment