lt1 engine bay

[s-10fan262]

i have a 1995 trans am with ram air and lt1... does anyone have any pics or walk throughs of relocateing the passenger side wheel well wire harness or the fuel lines or other cool ideas and pics... thanks

[Fish-man]

i have a 1995 trans am with ram air and lt1... does anyone have any pics or walk throughs of relocateing the passenger side wheel well wire harness or the fuel lines or other cool ideas and pics... thanks

Go to ls1tech... use search... i'm sure i've seen it there

[FASHOOTER]

Lots of good info on LS1 tech. I relocated the passenger side harness, and the hood latch cable. Haven't looked into the fuel line relocate.

[meissen]

I did the fuel line relocation and passenger side wire mod. I still need to do the hood latch cable. Basically you drill a hole through the strut tower for the wires or fuel line and then reroute them through the hole. For the passenger side wire mod, you drill the hole and then route the wires through the hole, between the strut tower and the plastic wheel well cover, then by the battery there's an opening that you can route the wires back out through. For the fuel line relocation, once the hole is drilled you route the fuel lines out through the hole (it will come out by the master cylinder) then you just route the fuel lines behind the master cylinder and back into the fuel rails.

[s-10fan262]

cool ill have 2 look at urs this weekend...

[BP_Z28]

http://www.flickr.com/photos/lswon/2...7603647740314/

Done on an LS but should be about the same I assume

[meissen]

http://www.flickr.com/photos/lswon/2...7603647740314/

Done on an LS but should be about the same I assume

This is the exact same process as the LT1.