Announcement

Collapse
No announcement yet.

Need help IN LANSING

Collapse
X
Collapse
Who has read this thread:
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Need help IN LANSING

    if anyone is close to lansing and wouldn't mind giving a helping had....i need some help pulling tranny out and changing my throwout bearing. not that hard of a job...i must of had the tranny in/out 5 or so times. long story short i need to put in a thicker bearing to get full throw on my clutch. too many custom parts....here is the what the car looks like..



    1987 IROC-Z, 406 SBC, Tremec 3550, 12-Bolt rear. LOTS of other parts
    Tags: clutch., throwout bearing
  • #2
    man if you were closer i'd come help cause i never installed a stick before so i wouldnt mine learning .... that a t5 or t56
    The Original




    Originally posted by 81DaytonaPaceCar


    Can you argue that it's "revolutionary"? Perhaps. Just because it's "new" and "different" doesn't mean it's the greatest thing since sliced bread.

    Comment

    • #3
      tremec 3550 5-speed

      1987 IROC-Z, 406 SBC, Tremec 3550, 12-Bolt rear. LOTS of other parts

      Comment

      • #4
        o shit that killer where u pick that up from?
        The Original




        Originally posted by 81DaytonaPaceCar


        Can you argue that it's "revolutionary"? Perhaps. Just because it's "new" and "different" doesn't mean it's the greatest thing since sliced bread.

        Comment

        Previous template Next
        Working...
        X