Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Yes, he did a very nice job on them. I think they will work out well.
- 1 like
-
I did not work this weekend that I can recall. This week is quickly turning miserable though.
I did get the wheels back from refinishing....
Leave a comment:
-
Yes, it needed doing. So it's nice to have it done. Putting the last coat of paint on the fasteners (which will probably flake off as I install them,...
- 1 like
Leave a comment:
-
Sadly, just been too busy this week to et anything meaningful done. Got my fuel filter bracket media blasted, primed and painted, fasteners too. Not very...
Leave a comment:
-
Yes, I've done some bolt-ins in my life, but this was the first one of these. If you see the General trying to bring this design back, be sure to smack...
- 1 like
Leave a comment:
-
This was removing the driver side rear drum brake wheel cylinder. Rather then being bolted to the backing place as they were for generations, the later...
Leave a comment:
-
This was a bad car week. Too busy at work to do much. Holiday is finally here and I don't feel well today. Tomorrow will be house cleaning for company...
Leave a comment:
-
Yeah, some things never change. Including...I took Tuesday off "just in case" I don't get enough done through the weekend. And as of today,...
Leave a comment:
-
Yeah, me either. That surprised me.
Ran out at lunch and returned the wheels for re-coating. Stopped on the way back and picked up the new...
Leave a comment:
-
SUNDAY: Didn't feel the best this week/weekend. I did get the driver side rear drum brake disassembled. Decided to give the special tool for the wheel...
Leave a comment:
-
Happy Anniversary to my T/A. Bought it 10 years ago today.
After a couple of days of soaking Blaster, the nut came loose from...
Leave a comment:
-
Tire/wheels change sounds like a great opportunity to soak those bleeders and let them sit while you decide to upgrade or not.
...
Leave a comment:
-
There's a step in the shaft that is part of the surface the strut bearing rotates/steers from, and it sits at the bottom of that step.
Koni...
Leave a comment:
-
We'll see what the guy has to say about the wheels. I'm not inclined to spend more money on these things.
I'll make some calls tomorrow,...Last edited by DynoDave; March 18th, 2024, 03:20 AM.
Leave a comment:
No activity results to display
Show More
Leave a comment: