Click here for Advertising Information
CC Performance - Horizontal

+ Post New Thread
Page 1 of 49
1 2 3 4 5 11 ... LastLast
Threads 1 to 20 of 970

Forum: Fourth Generation

Anything specific to your Fourth Generation can be posted here.

  1.   Sticky Threads  

  2. Sticky Thread Sticky: 25th Anniversary TA production info......

    Just thought I'd pass along a little 25th Anniversary TA knowledge to everyone...Hope you enjoy!! Production of the 25th Anniversary TA was...

    Posted By 92conv
    2 Pages
    1 2
    • Replies: 11
    • Views: 796
    January 10th, 2010 11:05 PM Go to last post
  3. Sticky Thread Sticky: OBD1 DTC Codes Sticky

    Alright guys - because I'm always referencing my service manual, I decided to take pictures of each and every OBD1 DTC code as well as the...

    Posted By meissen
    • Replies: 2
    • Views: 234
    September 4th, 2009 11:28 PM Go to last post
  4. Sticky Thread Sticky: The Truth about Firebird Vins and RPO's

    Over the past few years I've seen several posts regarding questions on Vin identification and RPO misinformation specific to the 4th Gen V8...

    Posted By 9T8W66
    2 Pages
    1 2
    • Replies: 19
    • Views: 1,117
    January 5th, 2009 03:31 PM Go to last post
  5. Sticky Thread Sticky: V6 Modification Guide

    Well since we are beefing up the tech. I figure I would post this from another site. He did some nice digging and got some really helpful...

    Posted By Yoshi94
    • Replies: 6
    • Views: 1,001
    March 19th, 2008 11:15 PM Go to last post
  6. Sticky Thread Sticky: V6 Year-to-Year Comparison

    1993 1993 was the first model year of the fourth generation F-Body. The L32 (3.4L) V6 was the engine for the base model. The standard transmission...

    Posted By 97rs4life
    tail lights
    • Replies: 5
    • Views: 838
    March 1st, 2008 09:48 AM Go to last post
  7. Talking Sticky Thread Sticky: So you wanna be fast...

    Well start by reading here, you will learn a lot about your 4th gen! No FI help is here, just ask, someone here can lend a hand... ...

    Posted By shiftinda93z
    articles, body, closed, eve, good, imo, informative, jerk, lol, ls1, ls1tech, make, newer, owner, pos, power, put, speak, sticky, stuff, tech, technical, thread, wrote, year
    • Replies: 7
    • Views: 1,330
    July 26th, 2006 04:55 PM Go to last post
  8. Sticky Thread Sticky: Some Helpful Install Guides

    I just figured id share these sites that have helped me with alot of new installs and questions. I hope this can be of some use to you and feel free...

    Posted By 99TransAmWS6
    alot, feel, figured, free, good, guide, guides, hat, helped, helpful, hope, howto, install, installs, ls1, material, pos, post, questions, share, sites, stall, stalls, url
    • Replies: 0
    • Views: 1,041
    July 26th, 2006 12:52 PM Go to last post
  9.   Normal Threads  

  1. Looking at sub-frame connectors...whats good?

    Okay guys i need to get some subframe conectors is the first step in my build and there are a hell of a lot to choose from. So my question is whats...

    Posted By Purple94Z28
    9 Pages
    1 2 3 ... 9
    build, camaro, choose, conectors, ded, fine, good, greatly, guys, hell, highly, idk, input, ion, lot, needed, point, put, question, step, stuff, subframe, umi, weld, work
    • Replies: 81
    • Views: 734
    Today 12:04 AM Go to last post
  2. Refinishing my valvecovers

    My centerbolts came in yesterday! They came off of a 5.3l truck ls1 so I hope they're the same, but I already started to polish them. First step is...

    Posted By Fbomb
    2 Pages
    1 2
    • Replies: 12
    • Views: 136
    Yesterday 11:35 PM Go to last post
  3. 02 v6 Firebird Whisper lid

    Does anyone know where I can find a whisper lid for my 02 v6 bird? If not will a v8 lid work on a v6, if so how is it done. Thanks

    Posted By pilotb19
    003, 100, aluminum, bird, find, firebird, fit, fittings, lid, mifbody, pos, post, thread, tubing, vbulletin, whisper, work
    • Replies: 2
    • Views: 28
    Yesterday 08:53 PM Go to last post
  4. stripped valve cover bolt

    my cuzins was tightining the back top bolt on the valve cover and over tightened now the bolt is just spinnin in the head? will this bolt make the...

    Posted By DJS Z28
    back, bolt, building, cars, cover, gettin, good, head, ing, invest, leak, make, nin, plz, pulling, ripped, spin, stripped, suggestions, top, torque, turn, valve, wrench
    • Replies: 5
    • Views: 70
    February 6th, 2010 08:21 PM Go to last post
  5. Let the winter build start :)

    Well its official, my winter build is finally starting!! i got the rebuild kit yesterday, also picked up some headers a couple of months ago. With...

    Posted By kyleozzie
    6 Pages
    1 2 3 ... 6
    albums, alot, awesome, bbk, bet, body, gonna, good, great, hat, holley, ing, kyleozzie, lol, mine, photobucket, polished, pre, pretty, project, run, running, throttle, today, wait
    • Replies: 50
    • Views: 615
    February 6th, 2010 11:12 AM Go to last post
  6. cam retainer plate?

    i installed new cam and the plate around it has a orange pressed in gasket, can i re-use same one or go to dealer and buy a new one? plz help

    Posted By DJS Z28
    buy, cam, dealer, fine, gasket, installed, orange, original, plate, plz
    • Replies: 1
    • Views: 36
    February 4th, 2010 10:09 PM Go to last post
  7. NEW Battery relocation?

    Well been messing around with the idea of relocating battery but between cables,bracket,box,shut-off etc. it could be around 300 or so and extra...

    Posted By 01badbird
    • Replies: 0
    • Views: 37
    February 4th, 2010 03:47 PM Go to last post
  8. 2001 Camaro Clutch Info.

    I am going to replace the clutch in my 2001 SS. The questions I have are should I upgrade the clutch kit to a stage 2 (just a mild upgrade) or just...

    Posted By bfranz48154
    2 Pages
    1 2
    200, 2001, bank, big, brand, budget, buying, camaro, car, clutch, good, great, info, information, kit, plans, power, questions, replace, save, shop, stage, stock, upgrade, website
    • Replies: 13
    • Views: 135
    February 4th, 2010 01:12 AM Go to last post
  9. LT1 vs LS1 it's a question of torque

    Was looking for LT1 vs LS1 torque graphs when I came across this link of an old discussion. The key post is Fred's (Injuneer) who is a well known...

    Posted By 9T8W66
    4 Pages
    1 2 3 ... 4
    250, 500, body, discussion, end, found, guy, horsepower, key, link, low, ls1, lt1, magazine, original, post, question, questions, rpm, star, start, thread, torque, war, years
    • Replies: 31
    • Views: 396
    February 3rd, 2010 10:38 AM Go to last post
  10. too much fuel pressure

    i now have too much fuel pressure. 50 koeo (which is ok) and 75 at idle. my pump blew out the hose inside the tank. i made a trap door. i swapped...

    Posted By ckkhiller
    1badair, 255, 36#, back, blew, camaro, change, feed, fuel, hose, line, lines, low, lower, man, past, pressure, pull, pulling, pump, read, removing, stock, summer, watch
    • Replies: 7
    • Views: 102
    February 2nd, 2010 04:35 PM Go to last post
  11. Poll Poll: Need Some Opinions

    Well I need some opinions on which way to go with some vinyl for my car (nothing crazy). I am going to be ordering them soon (this week most likely)...

    Posted By 97BlackBird
    2 Pages
    1 2
    • Replies: 15
    • Views: 159
    February 2nd, 2010 10:00 AM Go to last post
  12. My car hesitates to start...... Help Me Please!

    For the past few weeks, when ever I go to start my car, it cranks over, but nothing, I will let off and crank it again and it starts right up and...

    Posted By jderry
    3 Pages
    1 2 3
    1/4, batteries, battery, car, cars, charge, charger, charging, check, dads, doubt, drops, engine, fuel, good, issue, key, light, long, pressure, psi, pump, rail, shows, time, turned
    • Replies: 27
    • Views: 234
    February 1st, 2010 12:09 AM Go to last post
  13. removing oil pump

    anyone know the best way to remove the 10mm bolt on the pickup tube? plz help

    Posted By DJS Z28
    bolt, box, break, cam, change, cover, end, finger, fingers, forum, free, oil, pan, pick, pickup, plz, pump, reason, remove, removing, thread, tube, turn, valley, wrench
    • Replies: 5
    • Views: 53
    January 31st, 2010 09:34 PM Go to last post
  14. valley plate

    any1 kno how to removal valley plate? the plate under the intake there is i think 2 sensors in the middle and i dnt kno how to remove them. plz help

    Posted By DJS Z28
    alright, any1, cap, con, connector, forum, intake, kno, knock, man, middle, moved, plate, plz, pretty, put, removal, remove, sensor, sensors, simple, sor, thread, today, valley
    • Replies: 4
    • Views: 63
    January 31st, 2010 08:02 PM Go to last post
  15. rear-end help

    i have 97 trans am with abs i just bought a new rear end. my abs wasnt working in my old rear end. (bit of backround) so i took old rear end out saw...

    Posted By ba_ta_97
    abs, bit, bought, called, camaro, care, end, hose, housing, plug, posi, properly, rear, ron, rotors, sensor, sensors, speed, top, trans, version, wondering, working, worry, year
    • Replies: 4
    • Views: 73
    January 29th, 2010 12:52 PM Go to last post
  16. Need help before spring hits

    Before the new season of driving hits, I have some issues I need to fix. First I need to replace a missing right fog light since I hit an animal; is...

    Posted By bfranz48154
    2 Pages
    1 2
    camaros, car, clutch, cons, cruise, dow, dream, hard, heat, issue, luck, making, people, pressure, pulling, seconds, show, sports, star, sucker, takes, tires, window, woodward, year
    • Replies: 19
    • Views: 213
    January 27th, 2010 06:34 PM Go to last post
  17. crankshaft question?

    just got back from the machine shop, he seems to think i need to upgrade my crankshaft to at least a cast steel. has anyone heard of stock LT crank...

    Posted By kyleozzie
    3 Pages
    1 2 3
    • Replies: 20
    • Views: 171
    January 21st, 2010 02:38 PM Go to last post
  18. Does the 4th Gen SS Hood Fit a V6 Camaro?

    I'm toying with the idea of mimicking the look of the SLP Camaro RS on my car, but with an SS hood. However, I heard somewhere that the factory SS...

    Posted By ktl711
    • Replies: 5
    • Views: 86
    January 20th, 2010 02:21 PM Go to last post
  19. Help 2002 camaro

    It started with the cluster flashing (like when it starts) and the gauges dying. It happened when I was driving and if i shut down, the car would...

    Posted By ckkhiller
    • Replies: 6
    • Views: 108
    January 20th, 2010 12:06 AM Go to last post
  20. Can you re-screen a maf?

    I have had a broken maf floating around my garage for about a 2 years now so since i am unemployed i decided i would paint it today. I spent the time...

    Posted By Dewman
    • Replies: 2
    • Views: 74
    January 18th, 2010 09:03 PM Go to last post

+ Post New Thread
Page 1 of 49
1 2 3 4 5 11 ... LastLast

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 1 users browsing this forum. (0 members & 1 guests)


Click here for Advertising Information
CS3 Automotive - Horizontal

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Support MiFbody
Our Sponsors
Google Ad